top of page

Fusion Splicer & Consumable

Training & Development Board

Asset & Data Management

Copper,DSL,WiFi&Broadband Test

Copper Certification

Bit Error Rate (BER)

Asset & Data Management

Ethernet Test - Enterprise

Ethernet Test - Service Providers

Multi-Protocol Field Test

5G Installation & Maintenance Tools

Asset & Data Management

Antenna Alignment & Monitoring

RF Instrumentation

RF Spectrum Analyzers

Fiber Inspection & Cleaning

Dispersion Analyser

Asset & Data Management

Fiber Certification Tier 1

Fiber Certification Tier 2

Fiber Identifiers

Fiber Monitoring

Fiber Optic Sensors

MPO Test Equipment

OTDR & Software

Optical Power Meters

Optical Multimeter

Optical Loss Test Set

Optical Spectrum Analyzers

Fiber Optic Tester

Optical Power Meter

OPM C-Series, -50 to +26dBm

OPM C-Series, -70 to +10dBm

Multifunctional Power Meter, -50 to +26dBm

Multifunctional Power Meter, -70 to +6dBm

Mini Optical Power Meter

Optical Light Source

OLS, SM, 1310/1490/1550/1625

OLS, SM/MM, 850/1300/1310/1550

OLS, SM, 1310/1490/1550nm

OLS, SM, 1310/1550nm, -5dBm±0.5dB

FO Installer Package

Fiber Optic Installer Package

BASIC Installer Package

ADVANCE Installer Package

EXPERT Installer Package

Optical Loss Test Set

OLTS, LS 1310/1490/1550nm, -4dBm

PH300 Series OTDR 1310/1550 (26/24dB)

SmartOTDR, 1310/1550nm

Visual Light Source

PH Visual Fault Locator, 10mW, ~12km

Fiber Identifier

PH Optical Fiber Identifier

PH Fiber Launcher, G657A1, 1000m

Kumpulan Abex Sdn Bhd

Always Committed

Multilane

ML4064-XD-TL

Thermal Load

Contact Our Expert

ML4064-XD-TL is used for testing OSFP-XD transceiver ports under board level tests, by substituting a full-featured OSFP-XD transceiver with the ML4064-XD-TL. The ML4064-XD-TL covers all OSFP-XD power classes.

The ML4064-XD-TL is packaged in a standard MSA housing compatible with all OSFP-XD ports. It provides an economical way to exercise OSFP-XD ports during R&D validation, production testing, and field testing. It follows the CMIS standard.

Note: The ML4064-XD-TL operates as a thermal load and does not have capabilities to perform a highspeed loopback.

OSFP-XD MSA Form Factor
MSA Compatible Configuration and EEPROM
Programmable MSA memory pages
Custom memory maps
I2C Interface
I2C control from edge connectors and from rear pin header
Controller card with I2C Master, supports multiple modules, USB master
Sixteen independent power spots (maximum number of 11 spots can be activated simultaneously) dissipating up to 44 W
Seven temperature sensors
Voltage sensor
Temperature Monitor and alarms warning
Cut-off temperature preventing module overheating

OSFP-XD

Home | Products | Data Center | Test Solutions

bottom of page